K-8000D SD card controller




K-8000D Operation Manual

一、K-8000D Feature：
    1、32—65536 gray level control，Gamma correction processing 。
2、Support each regular and  anomalous  mapping
3、The controller have 8 channels，each channel support 512 pixel (Max)。
4、Controller support cascade connection ，wire length between each controller can   achieve distances of up to 200m (max) ，
5、K-8000D could support 30pcs different pattern .


备注：Remark:
1.Please contact sales or technical support person to know the details when you need to use the global wireless GPS
synchronization,
channel distributor and timing play.(备注：1、需要使用全球无线 GPS 同步、控台通道分配器和定时播放的时候请联系
销售人员或者技术支持了解详细情况)


二、Support chip：
 Standard DMX Protocol 250Kbps
Standard DMX Protocol 250Kbps
UCS1903 1909 1912 (High Speed)
Note：Single IC only need connect A and GND

三、right side view：
四、 丝印含义：
     The key implication ：
Key
implication
CHIP
 choose IC Type
MODE
Switch program file/ code writing
SPEED+
Speed +
Press SPEED+ and SPEED- in the same time，Program file  Loop Mode
SPEED-
Speed -

VCC
DC5V input
POWER
Power light
ERROR
Lamp Error Detection
SD卡/SD CARD
SD card slot
    
Output signal（485 signal）：
A
signal+
B
signal-
GND
Ground
ADD
Write code line


     
     


五、写码过程：The process of write code
接线方式：
      启动状态The state of startup

        Chip00—03表示支持的IC  Chip00—03 The IC of support(表示支持的 IC)
        00——标准DMX 250KB  00——Standard DMX 250KB(标准 DMX 250KB)
        01——标准DMX 500KB  01——Standard DMX 500KB(标准 DMX 500KB)
        02——UCS窗帘灯      02——UCS curtain lamp(UCS 窗帘灯)
        03——UCS1903
       
Chip04—06 The IC of write code(表示写码的 IC)
04——UCS512A write code (UCS512A 写码)
05——WS2821 write code (WS2821 写码)
06——Temporary is empty (暂时为空)
Ch.03
Represent 3 channel（表示 3 通道）       
Note: Long press “Mode” 8 second, can UCS512 write code directly. The mode of write code is default 3 channels.
(注：长按 Mode 8 秒可直接 UCS512 写码，写码模式为默认 3 通道)


六、加密词汇解释 The explanation of encrypted vocabulary
Password is OK
密码正常！
Num
剩余开机次数
Password exist
密码已经存在
Can't repeated
不能重复加密
Set Password OK
设置密码成功
Clear Pwd OK
清除密码成功
Pwd not right
密码不正确
No Password
密码不存在
Has expired! Contact factory
密码已过期，请联系工厂！

七、接线方式The mode of connection

Remarks: 1. If the distance between controller to LEDs over 50meters, suggested to add a repeater.
2. If couldn’t pull the synchronization signal wires of the controller between two buildings, it is recommended to use global wireless
GPS synchronization module.
The details please refer to the synchronization scheme of GPS synchronization module.
3. The wires of transmission signals are recommended to use good quality HSYV or RVVP shielded wire to transmit.
(备注：1、如控制器到灯的距离超过 50 米时建议加一个差分中继器。
2、如两栋大楼之间的无法拉控制器的同步信号线，建议使用全球无线 GPS 同步模块，详情请查阅后面的 GPS 同步模块同步方案。
3、传输信号的线材建议使用质量好的超五类网或 RVVP 屏蔽线进行传输)


八、具体参数：Specific parameters
   SD card：
         Type：SD card
          capacity：128MB—2GB
          Format：FAT
          File Format：*.led
   Physical data ：
         Working temperature ：-30℃—85℃
          VCC：DC5V
         Power：3W
     GW：0.8Kg


九、注意事项：
     1.Before coping the files to the SD card, must to format the SD card first. Pay attention, it’s must to format the SD card
before coping files every time.
2.SD card must formatted as “ FAT” format.
( 1、将文件拷贝到 SD 卡之前，必须先对 SD 卡格式化，注意是每次拷贝之前都要格式化。2、SD 卡必须要格式化
成“FAT“格式.)
     Remark: The SD card in controller can not hot-plug or hot-swap, must disconnect the power of the controller first.
(备注：控制器上的 SD 卡不可以热插拔，即每次插拔 SD 卡时，必须先断开控制器的电源)

评论

发表评论

此博客中的热门博文

Ws2813 RGB Led Chip Data sheet

图片
Shenzhen Witop technology Co,.Ltd www.witop-tech.com                  Ws2813 RGB Led Chip                     Features and Benefits 1、 The control circuit and the LED share the only power source. 2、 The control circuit and RGB chip are integrated in a 5050 components, to form an external control pixel. 3、 Using the built-in signal reshaping circuit to achieve the signal waveform shaping, and no distortion of waveform of signal takes place. 4、 Built-in power-on reset and brown-out reset circuits. 5、 The gray levels of each pixel are of 256 levels, which achieves “256*256*256=16777216” full-color display, and the refresh frequency reaches to 2KHz/s. 6、 Serial cascade interface, data receiving and decoding depend on just one signal line. 7、 Dual-signal wires version, signal break-point continuous transmission. 8、 Any two point the distance more than 3m transmission signal without any increase circuit. 9、 When the refresh rate is 30fps, cascade numbers are far more tha
阅读全文

RGBW VS RGBWW RGB VS RGBW

图片
Add:3/F,Building A,Jinmao Technology Park,Tangyanshan lndustrial Zone Tangkeng,Shiyan,BaoanDistrict,Shenzhen Email:jessie@witop-tech.com  phone:0086+15676178187 RGBW  VS RGBWW RGBW LED strip has been around for a while now and has opened the door to previously unheard-of lighting possibilities, allowing not only a wide range of customisable colors but also the ability to cut and join any length to create totally unique shapes. In response to popular demand though, there's now a new kid on the block, RGB+WW, which adds an extra white chip into the mix. Why might you need this? Read on.. What’s the difference between RGBW and RGBWW LED strip? Standard RGBW LED strip uses a 4-in-1 LED chip made up of red, green,blue and W chips. It can produce a wide range of colors by mixing the four  and looks almost white with all  at full brightness. RGB+W+W LED strip uses either a 5-in-1 LED chip that has A Warm white chip and RGB Led, also has a White color on the right.
阅读全文

K-1000C SD card controller

图片
Email：jessie@witop-tech.com                    phone:0086+15676178187  Tel:0086+0755-23081280 WTP -K-1000C Using Manual 一、 K-1000C system features: 1000C SD Card Controller K-1000C system features: 1 、 32 to 65536 degree Gray control, Gamma correction procession handle. 2 、 Support various point, line light source, and all kinds of rules and specific shaped  h andle. 3. The controller has one output port, can support up to 512/2048 pixels(DMX lighting support   up to 512 pixels). 4 、 Play content stored in the SD card , the SD card can store up to 32 effects File, SD card   capacity support 128MB-32GB. 5 、 The controller can single set use,also multiple controllers cascade, cascade optical   isolation mode: interference, better stability, cascade distance between two controllers can   reach up to 150 meters, need to use 0.5M² pure copper power cord. 6 、 The controller support chip can lock the support IC in software, or not lock the support   IC in the software, sele
阅读全文